LASER DIODE DRIVE CURRENT OUTPUT

• Compliance Voltage Range: 0.12 - 24.00 Volts
• Output Current Range: 0.00 - 22.00 Amps
• Current Noise & Ripple (rms): < ± 0.5% of Full Scale
• Current Setpoint Accuracy: ± 0.5%
• Current Setpoint Resolution: 6 mA
• Current Stability (4 hours): ≤ 100 ppm
• Current Limit Setpoint Accuracy: ± 2%
• Photodiode Current Measurement Accuracy: ± 0.5%
• Photodiode Current Measurement Range: 0.00 - 700 μA

INTEGRATED LASER DIODE PROTECTION FEATURES

• Soft-Start Current Ramp to Setpoint (User Programmable)
• Soft-Start Current Ramp Factory Default Set to 300 Milliseconds
• User-Programmable Current Limit
• Open Circuit Detection; Short Circuit when Laser Diode Current Turned OFF
• ESD and Power Surge Clamp, AC Line Filter
• Reverse Voltage Transient Clamp
• Safety Interlock Connection
• Programmable Temperature Limits (Upper and Lower)

TEC TEMPERATURE CONTROLLER

• TEC Output Power Total: 192 Watts
• TEC Output Current Range (bipolar): ± 8.00 Amps
• TEC Output Voltage Range (bipolar) : ± 24.00 Volts
• Temperature Sensor Inputs: 10 kΩ Thermistor, NTC, PT100, PT1000
• TEC Control Loop Algorithm: Full P.I.D.
• P.I.D. Variables: User Adjustable to Optimize Temp. Settling Speed
• TEC Setpoint Resolution: 0.01°C
• TEC Output Stability: ± 0.01°C (subject to ambient temp. stability)
• Temperature Range: -25°C to 150°C
• Factory Set Default Lower Temperature Limit: 5°C
• Factory Set Default Upper Temperature Limit: 35°C

QCW PULSE MODE AND MODULATION

• QCW Pulse Width: 25 μsec to CW
• Pulse Time Base Accuracy: ± 1.0%
• QCW MODE 1: User Adjustable Pulse Width and Repetition Rate using Internal Pulse Generator
• QCW MODE 2: External Trigger to Internal Pulse Generator: Rising Edge Triggered QCW Pulse with Internally Adjusted Pulse Width
• Modulation Input: BNC, Digital (TTL) or Analog, 10kΩ Impedance
• Modulation Input Voltage Range: 0 ~ 4 Volts (4V = Max Current)
• Analog Modulation Bandwidth: 1 Hz – 20 kHz

AUXILIARY FUNCTIONS

• Temperature Sensor Input: 10kΩ NTC Thermistor
• Photodiode Cathode (Analog Connected to Gnd)
• Pilot Laser Anode, vs. Ground: (4 - 5V, 150 mA)
• Modulation Input
• Electronic Safety Interlock
• RS232 Connections
• External Fan Control Circuit, 2 - 24V, 800mA (max)

USER INTERFACE AND CONNECTORS

• RS232 Standard
• LabView Drivers Included
• Laser Connector: DB-7W2, Female
• Support and Peltier Connector: SubD-15, Female
• Main Power Connector: MOLEX Housing 10013036; Terminal 8701031

DIMENSIONS AND POWER INPUT

• Power Input: Universal 90V ~ 230 VAC, 50/60 Hz
• Dimensions: 85 mm (H) x 105 mm (W) x 204 mm (L)

RECOMMENDED ACCESSORIES

• kab-39 Unterminated Connecting Cable -or- kab-231 Terminated Connecting Cable